Here are pictures of the DARC Board - blank, and then completed without the chips installed. The DARC Board is an Atmel AtMega (CPU/MCU) based controller board for hobby robotics, designed by Kerwin, the lead of the DARC robot club in Denver.
I put together this controller board with my son, 11yo.
In the pictures on my Roboton Log you will see the minor changes I made to the DARC Board. I soldered the power regulator higher, and bent over the board, so it would not stick up so much higher than the rest of the board. I swapped the 5 pin programming port from male to female, to match the plug/wire I already had for my TTT-based Tuna bot.
Comments